Nowadays, more and more livestock and poultry farms would like to buy
Feed Truck for their plants. If there is 380 volts three phase, then electro
nci feed truck will be your best choice. And if there is no 3 phase 380volts, then we can choose hydraulic feed truck. More and more people perfer to hydraulic system discharging feed trucks.
Chengli Special Automobile Co., Ltd. Is the leading manufacturer and supplier of feed trucks in China. With many years’ development, we Chengli Company can manufacture and sell farm-oriented feed trucks(electro
nic system discharging or hydraulic system discharging) from 8m3 to 40m3 and 40m3-50m3 animal feed transported semitrailer, etc. And more and more CLW Brand feed trucks have been exported all over the world.
2016s best seller-do
ngfeng duolika hydraulic feed truck
2016s-best seller-do
ngfeng tianjin 20m3 hydraulic feed truck
Today, we will introduce how to operate hydraulic feed truck as below
I think there are three steps to finish.
First step, operation of the driver cab.
Second, operation at the left toolbox
Third, operation at the rear part of the truck
First, at the driver cab.
A, start the truck; B, step on the clutch; C, Open the PTO
Second, at the left toolbox operation
We should know the function of the 5 shafts above.
The left one with red color is hand throttle(push-up to accelerate the engine); and the right 4 o
nes are remarked with 1, 2, 3, 4 above.
1 shaft is to co
ntrol the top auger lifting and dropping. Push-up the 1 shaft refers to lifting function; then pull-down refers to dropping the top auger.
2 shaft is to co
ntrol the top auger left-right rotating. Push up the 2 shaft refers to right rotation; then pull-down refers to left rotation.
3 shaft is to co
ntrol auger at the tank bottom to rising and discharging. Push-up refers to lifting the feed, o
nly in forward-rotating.
4 shaft refers to co
ntrol the top auger feeding. Push-up refers to feeding, o
nly in forward-rotating.
And the operation steps of the toolbox as below
A, push up the 1 shaft to lift the top auger;
B, push-up and pull-down 2 shaft to left-right rotation, then find the place of the feed silo
C, push up the 3 shaft to lifting the feed
D, push up the 4 shaft to feeding the feed to the feed silo
E, push-up the manual throttle; if the truck operate so hard then accelerate the manual throttle.
Then if close the truck, first close the manual throttle, then 4-3-2-1
Last the operation at the rear part of the truck.
The 2 sets of the operation manual shaft to open the compartments of the feed truck
1 refers to the compartment 1; 2 refers to compartment 2. discharging one by one. The upper part means close the compartment, close position.
Pull-down operation shaft to discharge feed gradually one by one.
If close the feed truck, then close in reverse.
For more information, please contact us email:[email protected]